PERFORMANCE TAIL CONTROL FOR ALIGN TREX 500 ELECTRIC SERIES HELICOPTERS

Note: the KDE Direct TREX 500 Series Performance Tail Control assembly is the ultimate, slop-free control system
available on the market to provide precise tail control and authority. Add the KDE Direct TREX 500 Series Performance
Tail Upgrade V2 to the system and you now have a complete, dual-radial ball bearing supported assembly throughout for
the ultimate flight characteristics. With the mechanics of the dual-fork supported tail slider, there is no worry of abnormal
wear or torque loads on the tail shaft slider for a continuously smooth, failure-free operation even under the hardest and
most extreme flying conditions.

Important: due to the precision CNC-machining of each component,
correct installation is key for proper, bind-free operation. Please pay
attention to the Installation Instructions, take your time during the
install, and make sure to apply medium-strength Loctite (Blue 243 or
equivalent) to all screws during assembly. Once fully-installed, a
significant reduction in slop throughout the tail mechanics will be
clearly evident on the bench and in actual flight.

Includes:

- One (1) TREX 500 Series Aluminum Performance Tail Control Assembly
- One (1) TREX 500 Series Aluminum Performance Tail Control Secondary Link
- One (1) TREX 500 Series Aluminum Performance Tail Control Primary Link
- One (1) TREX 500 Series Aluminum Performance Tail Control Arm Lever
- One (1) TREX 500 Series Aluminum Performance Tail Control Bearing Holder
- One (1) TREX 500 Series Aluminum Performance Tail Control Bearing Collar
- Two (2) Radial Ball Bearings 6 x 10 x 3 mm
- Two (2) Flanged Radial Ball Bearings 3 x 6 x 2.5 mm
- Four (4) Flanged Radial Ball Bearings 2 x 5 x 2.5mm
- One (1) M3 x 0.5 x 14 mm Button Head Socket Head Cap Screw (Class 12.9 BP Alloy Steel)
- Three (3) M2 x 0.4 x 6 mm Socket Head Cap Screws (Class 12.9 BP Alloy Steel)
- Two (2) M2 x 0.4 x 5 mm Socket Head Cap Screws (Class 12.9 BP Alloy Steel)
- One (1) M3 x 0.5 Nylon-Insert Locknut (Zinc-Plated Class 8 Alloy Steel)
- Four (4) M3 x 4.8 x 0.3 mm Round Hole Shims (18-8 Stainless Steel)
- One (1) TREX 500 Series Aluminum Performance Tail Upgrade V2 (When Included)
- Two (2) TREX 500 Series Aluminum Tail Control Link V2
- Two (2) SAE 660 Bronze Sleeve Bushings 2 x 3 x 3 mm
- Four (4) Flanged Radial Ball Bearings 2 x 5 x 2.5 mm
- Two (2) M2 x 0.4 x 8 mm Socket Head Cap Screws (Class 12.9 BP Alloy Steel)

Finish:
Clear anodize, mirror-polish CNC gloss

Weight:
6 g (design is FEA optimized for maximum strength and minimum weight)

Installation Instructions: http://kdedirect.com/files/AT500-PTC_Installation_Diagram5.PDF